The charcoal machine production line is a very popular charcoal production equipment in the machinery market. It can turn a lot of agricultural and forestry waste into waste, and the machine-made of charcoal is also a new energy source favored by the majority of users in the market. The charcoal machine production line It also points the way for China’s environmental protection machinery industry.

Many users know that the charcoal making machine product machine-made sells well and sells a lot, but it is not clear that the machine-made charcoal has a lot of uses in life. The following is a detailed introduction for everyone. The grill we usually eat, many of which are used in the charcoal machine to produce charcoal, extra clean, smokeless, and heat is still large, but the brush pot that is usually eaten is also the machine-made of charcoal.

The charcoal machine production line fills the raw materials containing biomass fibers that can produce charcoal, such as branches, straw, straw, peanut shells, trunks, cotton straw, tea seed husks, husks, weeds, leaves, etc., and pulverizes them into 10 mm by a pulverizer. The powder inside is dried by the dryer to make the moisture content within 12%. After being put into the rod machine through high temperature and high pressure, it is formed (without any additives) and then placed in a 탄화로 for carbonization. charcoal. It is also possible to carbonize the material powder directly into a carbon powder using a continuous carbonization furnace.

Common faults and solutions for charcoal machine production line:

1. The rod making machine does not stick out. The reason is that the heating temperature is too high or too low, the forming sleeve of the rod making machine is worn more seriously, the angle of the screw propeller does not match, and the raw material moisture is too large. The charcoal making machine adopts the automatic temperature control device, and the forming sleeve is cast by high-alloy material, which is resistant to pressure and wear.

2, the salary bar does not form, the reason is improper temperature control, raw material moisture is too large, the rod machine propeller wear, the shaft tip is not correct, the vent hole is blocked, the rod machine propeller head spiral is too large or too small, the sleeve Serious wear and so on.

3. The quality of the salary bar is not high. If the moisture content of the raw material is too large, the rod body will be laterally cracked. If the moisture is too small, the longitudinal crack will easily occur. In addition, too high a heating temperature causes excessive softening of the raw material, which causes insufficient supply, which also causes cracks. Insufficient feeding of the feeding cylinder, the spiral diameter can be appropriately increased, or the spiral wall can be polished to increase the span between the spirals.

The raw materials used in the charcoal making machine on the production machine-made charcoal are all biomass waste, so it is favored by the majority of users, and the charcoal making machine cannot avoid failure during production, so the user should solve it in time, so that it can ensure its more Good production guarantees the production efficiency and effect of the charcoal machine production line.