The charcoal machine is short for several pieces of equipment: the charcoal machine equipment mainly includes a crusher, a dryer, a sawdust briquette machine , and a carbonization furnace.

The charcoal machine raw materials may be sawdust, rice husk, husk, straw, logs, branches, scraps and the like.

The moisture content of the charcoal machine should be less than 12%.

The charcoal machine production site needs to be larger than 50 square meters and the height needs to be more than 4 meters.

Use and characteristics

First, the product has reasonable design, reliable quality, simple structure, convenient operation, small size, small footprint, labor saving and power saving.

Second, the design of the fully automatic control electric heating device can randomly adjust the dry humidity of the material to ensure stable discharge molding and improve work efficiency.

Third, the main part of the product is treated with special wear-resistant materials, so it can be continuously pressed and produced.

Fourth, it is suitable for press forming of various biomass raw materials and has low energy consumption and high production efficiency.

Fifth, the three bearings of the old-fashioned movement are four, which increases the stability and durability of the machine.

Sixth, the old-fashioned oil-based lubrication is oil-immersed lubrication, as long as there is no shortage of oil, it can be used for many years.

Seventh, increase the pitch to increase the amount of feed, thus greatly increasing the output.

Eighth, the structure of the forming cylinder is improved, the friction between the machine and the raw material is reduced, and the density of the mandrel is increased.

Production Process

Charcoal machine production process: material crushing, drying, rod forming, carbonization. The main equipment is crusher, dryer, sawn wood briquetting machine, carbonization furnace.

It mainly consists of a bar machine and a dryer and is a special machine for mechanical charcoal. The dryer can automatically cut the material and dry it once. The exhaust port is not dipped. The discharge port does not spray the material and falls naturally. It can be used for the production of four-rod machines. The automatic temperature control rod making machine can adjust the stick at any time. Compactness, this technology not only guarantees the quality of the stick. Branches, leaves, sawdust and other agricultural products are used as raw materials. After crushing, they are pressurized and densified. Because they can replace traditional coal, they are called “straw coal”. It is an emerging fuel.

Production and processing procedures for charcoal machines:

The material is cut by a mower or pulverized by a pulverizer. The material grain length and water content are within the specified range: the material is evenly sent to the upper mouth of the molding machine by a loading machine (belt conveyor) or manually. Press forming is the finished product. From raw material source to fuel use process: raw material – crushing – drying – rod – carbonization – finished product.